The interior of Dongfeng Fengguang 500 is red, and the interior can be modified according to your own needs.
Notes on car interior modification:
1. It is not difficult to find seals on the edges of car doors, windows and sunroofs. These inconspicuous seals are often issues that car owners tend to overlook when maintaining their car. As we all know, automobile seal rings play a sealing role due to their colloidal properties. If the seal ring is exposed to the sun for a long time, it will age and crack easily, and the sealing performance may be greatly reduced. Not only will it affect the sound insulation effect of the environment inside the car, but in serious cases. , water leaks and water infiltration will occur. Beauty expertsautomobile emphasized that to properly maintain seals, car owners should start with the small, everyday things. The first step is to clean the seal ring. Car owners can clean the oil seal every one or two quarters. Specifically, you can wipe the dust on the slides and grooves with a clean, damp sponge first, and then wipe it again with a dry sponge to keep the seal ring clean. These operations are quite simple and can be carried out without going to a specialized car wash workshop. If you use a high-pressure water gun when washing your car, remember not to spray water directly on the seal ring, otherwise the seal ring will be easily deformed under the impact of the high pressure water column, this will affect over time. Sealing performance of seal ringed and makes the car more durable. Easy to enter the water.
2. For the edge of the veneer: We first heat the sticker on the edge of the veneer, then use a soft film to scrape the sticker from the front of the peach wood to the back of the peach wood to scrape the shape from the edge of the peach wood. The sticker that extends to the back of the peach wood also needs to be heated to remove moisture from the glue surface and make it stick firmly to the back of the peach wood.
For the corners of the decorative panel: We need to cut the stickers at the corners as shown, then fold them to the back of the decorative panel. Since the corners of the decorative board are curved, we need to heat the stickers at the corners and then scrape off the stickers. Since the sticker becomes soft after being heated, pulling it toward the back of the decorative panel will allow the sticker to fit very tightlyt to the edge of the corner of the decorative panel.
After a period of cutting, the degree of adhesion between the sticker and the surface of the peach wood will become quite high, and the sticker will also closely fit the shape of the edge of the peach wood. However, because we used a sprayer to wet the peach wood surface and the sticker surface before applying the sticker, blisters will appear during the subsequent heating process caused by moisture accumulation which was not evacuated. We can use a pin to pierce the sticker, drive out the water, then use a hair dryer to heat it and smooth it.