The oil-water separator light illuminates, indicating that the oil-water separator has malfunctioned and stopped working, prompting the car owner to stop for maintenance. The specific causes of oil-water separator are:
1. Flashing state: Due to excessive moisture content in the fuel filter, the oil-water separator cannot operate normally.
2. Always on: The relevant sensors that make up the oil-water separator are faulty, resulting in the inability to transmit the working status normally and stop working.
When the oil-water separator fails, the car will be unable to perform the normal steps of removing water when burning fuel. Failure of the oil-water separator can easily lead to abnormal operation of the fuel injector. thereby causing unstable engine acceleration, inability to accelerateer and emit black smoke; the engine emits serious carbon deposits and other problems;
Detailed information
Care and maintenance of oil-water separator:
1. In daily life, the filter can be cleaned regularly (open the discharge valve at the bottom of the separator to remove foreign matter).
2. When cleaning the oil-water separator, avoid using clean water to rinse it directly. Direct flushing can easily cause water to accumulate inside the oil-water separator and cause malfunction.
3. Under the guidance of professionals, adjust the opening degree of the drain pipe valve to maintain the pressure in the separator to facilitate the discharge of dirty oil inside the oil-water separator.
4. When the oil-water separator fails, the vehicle should be sent to an auto repair shop for professional maintenanceessential on time.
How to install the belt of JAC Ruifeng 1.9t diesel version
The average fuel consumption of JAC Ruifeng 1.9T diesel version is 6.5 liters per 100 kilometers,
JAC Ruifeng 1.9T The performance of the diesel version is not bad: the limit of 1.9T diesel Ruiying is 3.5L/100KM... This engine is very economical and has powerful power sufficient.
What does the fuel consumption of a car depend on:
1. If refrigeration and air conditioning are used
2. Driving conditions are the most fuel efficient. at constant speed and at economical speed
3. The lighter the vehicle, the more fuel efficient it is.
4. The more electricity it consumes, the greater the magnetism. generator resistance.
5. Driving habits, braking too much will definitely not save fuel.
6. The best engine temperature is enabout 70 degrees. If it is too low, the viscosity of the oil. will be high and lubrication will not be good. When the temperature is too high, oil adhesion is poor and lubrication is reduced. At the same time, the cooling fan turns on, which consumes energy and then oil.
7. Engine oil performance
8. Tire strength, wide tires have greater strength and the resistance also increases when they are short of air
9. Aerodynamics of Body Design Learn
What is the reason why the leg of JAC Ruifeng 1.9t diesel generator broke?
1. First, there is a parable. tooth into the groove of JAC Ruifeng 1.9t diesel generator and loosen the nut on the top.
2. Second, use a crowbar to move the generator away from the engine, then tighten the nut. Some do not need to loosen the screwnut, just tighten the nut directly with a wrench.OK.
3. Finally, install the belt.
This is all due to this engine.
If there is jitter or the problem is caused by your generator or the generator footrests are not installed correctly, you can reinstall it. To do this, purchase an original bracket and install it. Generally speaking, if the sub-factory brand is used, it will easily cause this breakage and breakage due to vibration. "
If you have replaced the original one and this damage persists, you need to check if the engine shakes more strongly. You need to replace the engine, gearbox and footrests. No. It is excluded that the vibrations of the engine caused the breakage of the support
.