Personally, I think it depends on where you are. If the wind is strong in a relatively remote place, the wind power generation efficiency will definitely be higher. But if the wind is not so strong on the continent, the efficiency of wind power generation will definitely be higher. Wind power generation may not be the same. It is not as good as thermal power generation, so I think it is relatively more reliable to choose thermal power generation.
A wind energy revolution generates approximately 0.1 kilowatt hours of electricity.
At rated speed, a 100 kW wind turbine generates 0.1 kWh of electricity per cycle. When wind power is sufficient and stable, a 2 MW direct drive wind power generator generates electricity every 60 hours. can generate 2000 degrees of electricity in one minute. It takes 3.5seconds to the fan blades to rotate once. Wind turbines between 50 W and 300 W are 12 V, wind turbines between 300 W and 800 W are 24 V wind turbines, and wind turbines over 800 W are generally over 36 V wind turbines.
< p>Wind turbines are electrical equipment that convert wind energy into mechanical work. The mechanical work causes the rotor to rotate and ultimately produces alternating current. Its operating principle is relatively simple. It is a thermal energy utilization generator that uses the sun as the heat source and the atmosphere as the working fluid. As an energy source replacing human and animal energy, it plays an important role in developing productivity. Wind power generation often has no fuel concerns and generally does not produce radiation or air pollution.Principles of productionWind energy
Types of generators include asynchronous, synchronous, horizontal axis and vertical axis. The principle of wind power generation is to use wind energy to rotate the blades of the wind turbine, then use a speed multiplier to increase the rotation speed to induce the generator to produce electricity. The blades are used to receive wind energy and convert it into electrical energy through the nose, and the fin keeps the blades facing the direction of the incoming wind to obtain maximum wind energy.
The rotor allows the nose to rotate flexibly to adjust the direction of the tail. The nose rotor is a permanent magnet and the stator winding cuts the magnetic lines of force to generate electrical power. Due to the unstable air volume of the wind turbine, the output of the wind turbine is 13-25V alternating current, which needs to be rectified bythe charger, then the battery is charged, so that the electrical energy generated by the wind turbine is converted into chemical energy.