First check whether the excitation circuit is broken and the fuse is blown.
If the machine is not producing electricity, it may be a problem with the generator or generator relay. The engine burns oil, or the oil pressure is insufficient, etc. For reference only, as for the engine oil light staying on, it may be due to a lack of engine oil. After replacing the wastegate, the Great Wall Fengjun 6 diesel pickup truck sped away, causing the engine to fail to start properly and vibrating. and was making abnormal noises, and the car's idling engine was above the throttle sender. It is mainly used to support the car's idling speed. Its purpose is to adjust the idle speed according to the engine load at idle speed. If the idle speed is shaking, you can check the fluctuation of the idle speed meter needle.alenti, which generally. indicates poor combustion.
The method is as follows:
1 When wrapping with polyester insulation tape, be sure to press half of the first circle and wrap 8-. 12 layers. Then wrap them again. Both layers are then wrapped with tape for added strength.
2. Remove the copper core of the vacuum pump cable from a place about 30-35mm long, wipe the copper wire with emery cloth, and remove the copper wire from the three-core cable. from a place about 30-35mm long, wipe with an emery cloth and plug the three-core cable and the copper wire part of the outer cable together. Then stick it tightly with fine copper, cut off the remaining part and flatten it with scissors to avoid knots.
3. Solder the three ends of the vacuum pump wires firmly with solder.The surface of the welding head should be smooth, without burrs or false welds. , the vacuum pump must be resoldered until the requirements are met.
4. Wrap the three wires together with plastic tape. Layer 1 is greater than 50 mm at the end of the insulating layer. The second layer extends 50mm beyond the end of the first layer.
5. After wrapping, use a pan of cold water to safely dip the wrapping line into the water. After 12 hours, the insulation layer should not be less than a gauge pressure of 50 MW500. Otherwise, it will need to be reconditioned if necessary.
6. The vacuum pump ground wire should also be packaged according to the technical requirements of submarine cable lines.
7. When connecting the vacuum pump, constantly observe changes in insulation resistance to avoid damage to the cable insulation.
8. After the vacuum pump is connected, when going down the well, constantly shake the insulation resistance to observe its changes to avoid the cable insulation being caught on the well wall if the insulation level is find. to quickly drop below 0.5 megohm, it is necessary to lift the device to detect the cause.