I did both. Both direct air cooling and indirect air cooling are based on water circulation cooling. Direct air cooling uses an air cooling island to utilize a large fan and the heat dissipation surface of the air cooling island. cooling. Yes, you can take a look at Suzhou Electric Field. Indirect air cooling is done by an intermediate cooling tower (similar in shape to a cooling water tower). There are intercooling triangles around the bottom of the intercooling tower. air convection inside and outside the intermediate cooling tower. You can take a look at the 660,000 units of the electric field in Qinling, Shaanxi.
What is the function of the air cooler on the steam turbine and when should it be installed?What is the function of the air cooler on the steam turbine and when should it be installed?h3>
Possible reasons and handling methods for poor performance of air cooler:< /p>
1, the cooling water pressure is low---increase the water pressure.
2. The cooling water pipe is clogged with foreign objects - clean and clean it.
3. The cooling water temperature is high: this is the most common problem in summer. You may consider using deep well water.
4. The air cooling chamber has a poor seal --- leak.
In addition, you can observe the temperature difference between inlet and outlet water and analyze the cooling effect of the chiller. If the efficiency has reached the standard, it is not a design problem.
What is the material of the water pipe that connects the generator air cooler to the generator and will it not form a loop?
Correct your mistake, c is the air coolerr of the generator. Its function is to cool the generator coils. When to turn it on depends on the temperature of your generator. If the temperature is low, the investment will be late, and most of them will be made before and after the rush (I don't know when to do it, but the theory is probably like this).
The water pipe is generally made of copper, 20 mm in diameter and 2 mm thick. The tubes are made of copper tubes with good heat transfer performance. Each group has two water chambers on both sides for water supply and return. The generator and rotor coil and iron core blow hot air to air cooling through the axial flow fan on the generator rotor. The water is cooled on the generator and then drawn into the rotor-stator air cooler through both ends of the generator. form a circuit, but that has nothing to do with thee electrical circuit unless a leak from the air cooler causes a reduction in generator insulation