There is enough space in front of the engine to operate. The fan and crossmember are also removed, just a few screws.
The next step is to remove the compressor from the air conditioner. Simply remove three screws and lower the compressor a little without removing it.
You cannot remove the screw under the generator without removing the compressor.
It's the screw. You just need to loosen it. There is no need to unscrew the nut as the hole is open.
Use the special tool to remove the one-way bearings, use an air cannon to remove it, then use an air cannon to reinstall it. Since the special tool provided is too small in the middle, an Allen key cannot be used. I could only take it to a car wash shop to replace it with a wind cannon, which cost ten yuan. Finally, install the removed items one by one and test drive the car.