Advantages: beautiful appearance, large internal space, suitable for dedicated operations. Cons: Interior design is average, not to mention performance. With less than 60,000 kilometers on the clock, it cannot shift into second gear and requires major repairs. The air conditioner burned out naturally and there were no repair points. Call customer service and be directed to the nearest service point in just one sentence. This is the closest place. I don't know, it's a shame, you can't brake when going down a long slope, otherwise the whole rear wheel will turn red. Reasons for choosing the car: The company buys them uniformly and the price/quality ratio is too low.
One million car purchase subsidies
Alternator belt installation diagram
Both cars are good. Tuano's longitudinally mounted engine has a more direct transmission, Chase and Yufeng ont a transverse engine. with a more complicated structure. ISF engine has a wide application range and large inventory, superior to Shangchai's SC25R and ZD25 engines. Foton has a wide distribution network and good service. Maxus and Yufeng are both front-engine and front-wheel drive models, with limited carrying capacity and wheelbase, and the wheelbase cannot be too long.
As shown below:
The generator belt of this model should drive the vehicle's generator and compressor. It is driven by the engine crankshaft, between the generator and the compressor. the compressor. There is an idler pulley, which is used to give belt pressure to the generator and compressor pulleys, and there is an idler pulley on top, which has the same function. The tensioner on the crankshaft pulley is an automatic tensioner, which generates belt pressure in real time depending on theoperation of the motor belt, allowing the belt to maintain the most precise tension.
Generator belt notes:
1. The grooved side of the pulley must match the groove of the belt, to ensure that the belt will not come loose from the pulley.
2. The plane side of the pulley must match the plane side of the idler pulley and tensioner pulley to avoid excessive belt wear.
3. When replacing the belt, it is best to replace the tensioner at the same time.
4. The belt should be checked frequently for cracks, and if so, it should be replaced.