The position of the timing pulley needs to be corrected and it can be installed as follows.
1. First, fix the position of the timing wheel shaft and hold the wheel shaft bulge outward.
2. Then use a wrench to fix the position of the timing wheel shaft to prevent the wheel shaft from moving when installing the belt.
3. Then move the engine timing pulley outward to make it easier to wind the belt.
4. Then install the timing belt onto the timing wheel shaft.
5. Then wrap the belt around the official idler pulley.
6. Then install the timing wheel housing so that the timing belt is installed.
How to disassemble and reassemble the JAC Refine 1.5-ti compressor pulley
The generator belt and belte air conditioning are not the same on the 17 JAC Refine S3. The generator belt is used to drive the generator to produce electricity, while the air conditioning belt is used to operate the air conditioning compressor. They have obvious differences in function and use.
Alternator belts are typically longer and wider than air conditioner belts because the generator must produce more power. Additionally, the generator belt is usually connected to the engine crankshaft wheel so that the rotation of the engine drives the generator. The air conditioning belt is usually connected to the air conditioning compressor to drive the air conditioning system throughout the rotation of the engine.
It should be noted that different models and engine configurations may vary. Therefore, in specific cases it isIt's recommended that you check the vehicle's manual or consult a professional auto repair technician to ensure you choose the right one. . belt. In addition, regular inspection and replacement of belts are also important steps to maintain normal vehicle operation and avoid breakdowns caused by aging or damage of belts.
Extended content: In addition to generators and air conditioning systems, modern cars usually have other drive systems, such as water pump drive belts, drive belts power steering pump, etc. Each drive system has its own specific belts to ensure the proper functioning of each component. Therefore, when purchasing and replacing belts, choose according to the specific needs of the drive system and carry out maintenance and replacement rregular to guarantee the reliability and safety of the vehicle.
1. First, use a Phillips screwdriver and special tools to remove the air filter; use a Phillips screwdriver to remove the front center screen, then use tools to loosen the generator bracket bolts and loosen the generator. . Remove the generator belt.
2. Next, use tools to loosen the A/C compressor bracket bolts and remove the compressor belt.
3. Finally, use a flathead screwdriver to wedge the flywheel into the small hole at the bottom of the gearbox. At the same time, use a tool to loosen the crankshaft pulley bolt and remove the bolt; ; now the pulley should be easily removed.