Hello, the oil in this air filter housing is fully sprayed from the engine end which you think can be easily removed by gently pulling, and flows into the air filter housing through the rubber tube. Have you recently had the generator oil changed? The second is that the part with the hole (this part is called the cylinder head cover) is broken and needs to be replaced. The other is that the engine ages, where the exhaust originally comes out, but once the engine ages, the engine ages. The cylinder is damaged due to poor sealing of the piston rings. The gas inside flows into the crankcase, increasing the amount of exhaust gas or causing the engine to spray oil. By the way, this phenomenon is called oil spraying, and it is also. a common phenomenon in domestic horizontal motors after aging! I don't know if you canYou understand what I’m explaining like that!
If the gasoline generator is not used for a long time, will the gasoline in the fuel tank expand?
Yes, when adding oil to gasoline generator, there is a small amount of oil on the side cover when adding engine oil, be sure to check the position of the oil clearly engine oil. Under normal circumstances, the engine oil can be filled to the middle position between the first and second marks on the oil dipstick. Adding too much oil will cause the engine oil to burn, spray the oil, and the engine will have insufficient power and shake.
The dangers of too much engine oil: the engine light is on
If you add too much engine oil, The engine speed will increase slowly when accelerating. This is due to the increased resistance to internal movement. The increaseIncreasing the resistance to internal movement will result in an increase in vehicle fuel consumption. Too much oil can also damage the three-way catalytic converter. When refueling, it must be between the minimum and maximum scales of the gauge. The oil level cannot be lower than the minimum scale nor higher than the maximum scale.
If the pilot adds too much oil when refueling, he can let it drain or pump it out a little. Oil is called the blood of the engine. Engine oil plays a role in lubricating, heat dissipating, cleaning and sealing the engine. Without oil, the engine cannot run properly. If too little oil is added, the oil in some parts of the engine will not be lubricated, increasing engine wear.
If the gasoline generator is not used for a long time, the gasoline will not expand, but it will damage the tankfuel !
If you will not use your gasoline generator for six months or more, please make the following preparations before storing it.
1. The generator can be kept in a well-ventilated area with low humidity.
2. First disconnect the fuel hose, then carefully drain the remaining oil in the fuel tank and filter (cup). Leaving gasoline in the tank for a long time will damage the tank and make it difficult to restart.
3. You can loosen the oil drain screw on the carburetor float chamber to drain the fuel into the carburetor, or start and run a small gasoline generator without any load until it generates electricity . Stop until the engine fuels. is exhausted.
4. Disconnect the battery terminals. Then check the accumulator fluid level and add waterif necessary.
5. Change the engine oil. Used engine oil will produce a lot of residue and should not be left unused for a long time. A large amount of sediment will be produced, which will wear out small parts of the generator if used again.
6. Check if there is any play between the screws and bolts. Tighten if necessary.
7. Use an oily cloth to clean the gasoline generator thoroughly. Apply an antiseptic if necessary. Do not use water to clean the generator.