To disassemble the Airmate fan, you must first prepare a disassembly tool. Use the tool to unscrew the screws, then disassemble the fan arch and finally remove the fan blades. The specific content is as follows:
1. Prepare the disassembly tools. A Torx screwdriver or Phillips screwdriver is required.
2. Use a screwdriver to unscrew the fan housing screws. Do not be impatient or use excessive force when removing the screws.
3. Remove the hoop connecting the fan. You must hold the racks on both sides to avoid breaking or damaging other objects.
4. Remove the fan blade nuts one by one clockwise, then remove the fan blades.
Notes:
1. When disassembling, put the fixed cover in place to avoid wasting time searching for it. After disassembly, the fixations must be tightened during installation.
2. When carrying the electric fan, pay attention to your feet and furniture to prevent the fan from hitting the furniture or causing injury to you.
3. Electric fan blades are important components. They must be protected to avoid any deformation whether during installation, dismantling, cleaning or use.
4. If the electric fan feels hot to the hands, gives off an unusual burning smell, has difficulty shaking, or slows its speed during use, do not continue to use it and turn off the power. supply in time for maintenance.
How to replace the capacitor of an electric fan
Installation methods and steps for an electric pedestal fan:
Chassis installation .
First, remove the angle screw and pressure plate from the column, intighten the column into the base, place the pressure plate at the bottom of the chassis, and tighten it clockwise with the angled locking screw.
2. Overall installation
(1) First loosen the lifting lock nut, remove the lifting pipe from the column, and then use the lifting lock nut to lock the goods.
(2) Loosen the clamping nut at the bottom of the fuselage, insert the fuselage into the riser tube and tighten the clamping nut.
(3) Loosen the lifting lock nut, adjust to the required height and tighten the nut.
3. Install the rear grille
Unscrew the fan fixing nut from the motor shaft, then unscrew the triangular nut, then install the rear grille.
4. Install the fan blades
When installing the fan blades, the groove on the back of the fan blades should be stuck on the motor limit pin, and then tighten the nutu fixing counterclockwise.
The steps to replace the electric fan capacitor are as follows:
1. Disconnect power to the fan, then remove the fan cover and fan blades. (Fan blade screws are usually reverse threaded and can be loosened by turning them clockwise).
2. Once the fan cover and fan blades are removed, they can be cleaned with warm water.
3. Tighten the fan bearing rod by hand. If it spins easily, it means the capacitor needs to be replaced (replace the capacitor according to the original capacitor markings). If it cannot rotate or is very tight, remove the motor and repair the motor bearing seat, remove impurities and dirt from the bearing seat, then add sewing oil to lubricate it. General defects will be eliminated.
4. Add sewing oil, replace the capacitor and install the fan blade. At this point, the electric fan can be used normally.