Wind turbine wiring method:
The first step is to buy a socket. The power of the socket depends on the power of the equipment to be brought. First, use a razor blade to pry open the cover on the plug that comes with the generator. Take off the cover again, and you will see that there are three pillars inside the generator plug. Two of the pillars are the same length, and one pillar is much longer than the other two pillars.
The second step is to connect the wiring to two pillars of the same length. Because the socket has two wires, one is the neutral wire, and the other is the live wire. At this time, you only need to replace the plug at the ordinary socket with the special plug on the generator. At this time, just connect the wire on the socket you bought to the generator plug. The two wires are connected to the two pillars circled in red.
The last step is to use the two screws on the pillar to fix the wire. If you want to connect the power of the generator to the mains, you need to connect the wire of the generator plug. Go to the wires on the mains, and you don't need to buy a socket at this time.