Does the questioner mean to ask “What should I do if the generator exhaust area flaps are distorted when the generator is open? »
1. First, temper at a low temperature to remove internal stresses and restore the part to its original shape.
2. Secondly, without affecting the surface quality, sand the recessed parts to stretch the surface of the recessed parts, then inspect and level them while spraying.
3. Finally, use a rubber hammer to correct the part. This operation requires workers to have a certain experience. When hammering, do not hit the high pieces, but extend the short side to relieve the long side. correction.
General ventilation and process air supply in the diesel engine room are carried out by HVAC professionals. Others are determined by the electrical major. Forkeep it simple: when the diesel engine room is not producing electricity, the air supply and exhaust is provided by HVAC professionals and when the machines in the diesel engine room are working, the power supply process air is also provided at this time by the HVAC department; . As with process smoke extraction, these are determined by the electrical sector.