The main steps for starting the fan are as follows:
(1) Fans equipped with lubricating oil systems must first start the lubricating oil pump and adjust the pressure and the oil volume to normal.
(2) For fans that use hydraulic fittings to adjust the air volume, the auxiliary oil pump must be started to supply oil to the gears and bearings at all levels.
(3) Start the bearing cooling fan.
(4) Close the inlet and outlet baffles or set the moving blades to zero, close the scoop position to zero, and let the fan run without load.
(5) Start the fan and pay attention to the current swing time.
(6) After the current is normal, adjust the output to the required level.
(7) Carefully check the operating conditions of the fan.
A fantor is a machine that relies on mechanical energy supplied to increase the gas pressure and vent the gas. This is a fluid driven machine. Fan is the usual abbreviation for gas compression and transportation machines in China. Fans generally include ventilators, blowers and wind turbines.
Fans are widely used in ventilation, dust removal and cooling of factories, mines, tunnels, cooling towers, vehicles, ships and buildings, ventilation and induction drafting of boilers and industrial furnaces, as well as domestic cooling; and ventilation of electrical equipment; drying and sorting of grains, wind sources in wind tunnels and inflation and propulsion of hovercraft, etc.
1. First, a wind kinetic energy generator must be synthesized.
2. Once the kinetic energy generator is windnne made, you should choose a place with relatively strong wind. to put it down. Use an anemometer to find it, or simply build a high platform and land the machine after finding it
3. is the rotor. There are four types of rotors respectively. There are wooden rotors, iron rotors, steel rotors and carbon rotors.
4. The rotor is ready, click on the wind kinetic power generator, then place the rotor inside, then the rotor will start to rotate. If it doesn't spin, there isn't enough wind or something is blocking it;
5. After completing the above steps, you need to make a machine called a kinetic energy generator because the force of the wind. The kinetic energy generator only provides energy, but does not yet generate electricity. A kinetic energy generator is required to generate. electricity;
6. Oncethis is done, place it behind the wind kinetic energy generator, put it down and open it, and you will see that the kinetic energy generator continuously produces electricity;
/ p>