1. First, align the crankshaft according to the mark on the crankshaft timing pulley and require the top dead center position of the cylinder piston 1.
2. Next, install the camshaft timing pulley and align the marks on the camshaft. For dual camshafts, align the two camshaft positions.
3. Finally, install the timing belt and chain.
Why did the JAC Ruifeng engine shake after replacing the timing belt?
1. First of all, make sure that the power supply to Ruifeng air conditioner has been cut off to avoid danger. facility.
2. Next, loosen the air conditioning belt tensioner with a wrench.
3. When the belt is finally loose, remove the belt, place the new belt into the air conditioning system and pull it into the correct position. At the same time, you have to be careful. the tension of thebelt, neither too tight nor too loose.
You are right about the Ruifeng ignition timing belt. The problem may occur in the small belt of the oil pump. This belt is linked to the oil pump and the balance shaft. correct position. If the timing is good or bad, the question of appeal will arise. It is recommended to remove the timing and adjust the timing point of the balance shaft to resolve the problem.