Reasons for oil leaks from the air filter of gasoline generators:
Carburetor problems, carburetor oil level is too high or the float needle is stuck.
Solution:
Clean the carburetor.
To avoid injury, be careful of hot oil spills when replacing the oil filter. Air Filter Repair A dirty air filter will make starting difficult, cause loss of power, engine failure, and will significantly reduce engine life. The air filter must be kept clean at all times. In dusty environments, the air filter element must be replaced more frequently. Once the faucet and air filter cover are removed, the inner paper air filter element and outer urethane foam element can be removed. To install, place the paper element and urethane foam on the air filter base. Check that the seal is inplace, then replace the cap and tighten the faucet.
1. When the generator is used in an environment with high humidity in the air and prone to condensation, an anti-condensation heater should be added. When the generator is not working, the heater should be turned on. to keep the generator operating properly. If the body temperature is higher than room temperature, turn off the heater power during operation.
2. The generator protection level. IP21 prevents rainwater falling vertically from entering the interior of the engine. The IP23 protection level prevents rainwater at an angle of 60° to the vertical direction from entering the interior of the motor. engine. If there is a problem with the protection level. For higher requirements, IP44 or IP54 can be selected.
3. The generator is used in places where there is a lot of wind and sandor where there is a lot of dust in the air. An air filter can be installed, but this will affect power output. the generator and requires derating.
4. If the generator is subject to high humidity and is affected by condensation, salt mist, oil mist and mold, you can choose a marine generator and carry out three-level treatment.
In this aspect of process processing, Inge generators are very good. The patented technology of fully enclosed stator and rotor structures in special processes is particularly suitable for seaside salt spray corrosion environments, high humidity environments and strong chemicals. corrosive environments. Used in special environments such as wind, sand, harsh environments, etc.
I hope to adopt it.