Land Rover Range Rover Blower Motor Replacement:
1. Prepare the fan resistor, Phillips screwdriver and other tools for replacement, then turn off all electrical equipment and the car's ignition switch.
2. Disconnect the car battery and fan assembly connector (the fan is usually located under the storage box in front of the passenger seat), remove the fan fixed wiring harness, and then remove the fan assembly retainer. screw.
3. Find the resistor where the fan was removed (connected near the air duct), use a tool to remove it, and replace it with a new resistor.
4. Reinstall the fan and various circuits, turn on the battery, start the car and start the fan to see if the fan can adjust the wind speed.
1. Lift the loudspeaker coversleft and right lurtors of the car and remove the screws as shown in the picture.
2. Then lift the center windshield and remove the screws as shown in the picture.
3. Remove the two screws under the cigarette lighter as shown in the picture.
4. Remove the glove box screws as shown in the picture.
5. Then remove the screws on both sides of the front cover switch and horizontal bar as shown in the picture.
6. Disconnect the outer hose from the heater water tank as shown in the picture.
7. Remove the heater and you will see the heater water tank as shown in the picture.
8. Remove the water tank from the heater and finish.