The method of use is to connect the socket, turn off the circuit breaker, turn on the generator switch, quickly pull the starting handle to start the generator, and when normal, to Turn on the circuit breaker to power the equipment.
How to use a gasoline generator: 1. Check whether the box cover is covered well to avoid leakage and contact with high temperature parts while driving, which may cause a fire.
2. When checking the oil level, you need to make sure the oil level is on the low scale and 2/3 from the low scale to the high scale. Cannot exceed maximum score.
3. Check the oil level in the oil tank to ensure that the equipment uses oil normally to avoid sudden power failure when there is no oil during use.
4. Connect theform.
5. Turn off the breaker and turn on the generator switch.
6. Turn off the gasoline engine choke switch. This is because it can reduce the pulling force when starting and make starting easier.
7. Turn on the gasoline engine's fuel supply switch.
8. Support the generator skid plate with your left hand. After standing firm, quickly pull the starter handle with one force to start the generator.
9. Once the generator starts, slowly open the choke until it becomes larger. During this period, vibrations may occur at critical speeds. At this point, avoid resonance and equipment damage by quickly moving the throttle valve through this stage.
10. Operate the device for 2 minutes and observe whether the output voltage changes during this time. After normal operationwrong, open the circuit breaker to power the device.
11. After use, turn off the circuit breaker, unplug the plug and turn off the throttle to make it disappear automatically. In this way, the remaining gasoline in the carburetor can be used up. When gasoline is stored for a long time, it will deteriorate and block the carburetor inlet, preventing the equipment from cooling.
1. The electric starter usually starts immediately. If it doesn't turn on after two or three times, don't turn it on, as the battery still uses electricity to start. turn on, it is easy to cause the battery to collapse and die. Electrical damage to the battery.
2. Use kicks. In winter, the temperature is low and it is easy not to light the fire. Next, you need to tighten the gasket (also called choke). be pressed down. When starting the cold car in winter, il should be dialed up and placed in the middle about 15 seconds after getting into the car. When the car has finished warming up, return to normal state and press. all the way down. This process takes approximately three to five minutes.
3. Regarding the idle speed problem, sometimes the ignition cannot start because the idle speed is low. Normally in summer it is enough to set the mileage indicator to one division or more than one point. In winter, adjust it to more than one and a half and less than two.