There are many reasons why the car shakes! Do not replace the ignition system again. You can go to the store to clean the throttle valve and check the oil supply system. The filter must be a little clogged. also be replaced. If you can get to a repair shop, do so. Since you haven't completely fixed the problem after fixing it several times, their skills are not very good.
Why can't they. Ruifeng started the fire after running for a while?
If your JAC Ruifeng car battery heats up during charging and is discharged, it may be caused by the following situations:
1. The battery is old or damaged: The battery is in use. It may age or become damaged over time, resulting in reduced charging efficiency or the inability to store sufficient electrical energy. In this case,you may need to replace the battery.
2. Charging system failure: including failure of the charging line, charger or generator, preventing the battery from charging normally. You can check if the charging line is damaged or has poor contact, or try using another charger for charging.
3. Insufficient or contaminated battery electrolyte: Normal battery operation requires sufficient electrolyte. If the liquid level is too low or the electrolyte is contaminated, the battery charging effect will be affected. You can open the battery cover and check if the electrolyte level is normal. If it is insufficient, you can add distilled water. If the liquid is cloudy or has a strange odor, the electrolyte may be contaminated and it is recommended to replace the battery.
Whatever situation arises, I suggest you take your bikeTake it to a professional auto repair shop for inspection and repair. They will give you more precise solutions based on the specific situation.
Think back to the times
Regarding the situation you mentioned, one possibility is that the generator belt slipped or the generator itself failed, this which would make the generator's energy production too low. while the vehicle is driving, the power generated cannot reach the power required for normal operation of the vehicle. At this time, battery power will be consumed, causing the vehicle to fail to start after a period of driving. time. Another possibility is that the vehicle circuit itself has iron or power-consuming parts. Therefore, turning on the ignition switch will consume a large amount of battery power, which will prevent the vehicle from starting afters been driving for a while. Then you can check these two aspects. Both of these conditions can be measured with a multimeter. It is estimated that the store maintenance staff may find it inconvenient and do not want to check.
See more information about [JAC Ruifeng]: http://www.webcars.com.cn/jac-ruifeng/