Hello, Chris Generator will give you the answer about the choice of site and the environment of the wind turbine, i.e. "where can the wind turbine run continuously":
< p>1 The characteristics of flat land. require the fulfillment of two conditions:1. Within 3 to 5 km of the selected wind farm site, the terrain height difference is less than 60 m;
2. Within 3 to 5 km maximum slope; does not exceed 3%.
Selecting the location of wind farms on flat land is relatively simple, and the arrangement of wind turbines is relatively simple. You just need to take into account the roughness of the ground and the obstacles upstream and downstream. However, the anemometer tower must be installed in a location that best represents the wind resources of the wind farm. Avoid obstacles around. Especially in the direction of the prevailing wind, the horizontal distance from the obstacle should be installed at a position sugreater than 10 times the height of the obstacle. For example, if the wind measuring tower is installed. a protective forest or an anti-typhoon forest, it must be installed at a height of the forest greater than 10m.
2. Several points to pay attention to when selecting sites for complex terrain:
1. The crest should be as perpendicular as possible to the prevailing wind direction and the front. of the mountain should be far from the mountains or there should be no high mountains;
2. The top of the mountain should not be very flat and the slope should be uphill to the top of the mountain. should be as continuous as possible;
The increase in wind speed on the ridge is greater than that on the spherical mountain;
4. The increase in wind speed on steep mountains will decrease. quickly with changes in height compared to level ground;
5. The optimal slope is between20 and 30°, and occasional encounters of 30° on higher slopes should be avoided wherever possible;
6. The acceleration of wind speed with altitude on mountain ridges is not very high compared to that on flat terrain and will disappear quickly as altitude increases;
7 . Wind energy Topography adjacent to the field. has an impact on the structure of the air flow.
Spacing requirements for wind towers in offshore wind farms
Support devices for wind turbines. According to the official website of Jiuzheng Building Materials Network, wind turbine accessories are supporting devices for wind turbines. Wind towers are made of large diameter steel pipes and are equipped with accessories such as ladders, platforms, cable supports, electrical panel positioning, etc. Accessories are required to support the functionnormal operation of wind tower generators.
Should data from wind power generation wind measuring towers be transmitted to the Meteorological Bureau
The distance between wind power generation towers should be 200 meters. If one of them is too close, it will affect each other. Wind turbines are electrical equipment that convert wind energy into mechanical work, which causes the rotor to rotate and ultimately produces alternating current. Wind turbines generally consist of components such as a wind wheel, a generator (including devices), a steering (tail), a tower, a speed-limiting safety mechanism, and an energy storage device.
Requires transfer. In wind energy projects, anemometer towers are used to measure wind speed, direction and other meteorological parameters to assess the feasibility ofs wind resources. Data from wind towers should be shared or transferred with the relevant weather office or weather service. This involves using meteorological data for in-depth analysis of wind resources and operation management of wind power plants during the project assessment and planning stages, as well as during the operation phase.