I think the Fodi diesel pickup truck is a pickup truck with relatively good performance and configuration. It has good performance in power, chassis and appearance, and is very suitable for daily pickup truck applications. Personally, I really like its design, it gives people a different feeling.
The compressor of the air conditioner of the Foday Auto F16 van makes abnormal noise, and the air conditioner does not start and does not sound
The fault must also be caused by heavy fuel injection and mixture too rich. \x0d\The reasons are:\x0d\①, the intake air volume sensor signal is abnormal\x0d\②, the fuel injection signal corrected from the water temperature sensor and d sensor 'oxygen is abnormal\x0d. \③, the oil pressure of the fuel pump is too high\x0d\④ , there is a leak in the fuel injector\x0d\Check whether the volume sensor signals haveintake ir, water temperature sensor and oxygen sensor are normal, then check whether the gasoline pump pressure is within the standard range and whether there is leakage in the fuel injector. fuel, please repair it in time.
There are many reasons why it fails to boot.
The possible reason is that the compressor protection device has tripped.
The compressor overload protection tripping means that the system high pressure is too high or the overheat current is too large.
Causes and troubleshooting of excessive pressure and overheating:
1. Too much refrigerant. Appropriately reduce the amount of refrigerant.
2. Poor heat dissipation. Check the condenser tube for dirt and clean the condenser.
3. The piping system is blocked. Refer to the pressure gauge to judge, eliminate and redo system processing.
4. The evaporator or filter is dusty and limescale. The air flow becomes smaller and the system pressure and temperature become unstable. Clean the evaporator or filter.
5. Fluoride deficiency is also possible. If there is a lack of fluorine, the compressor exhaust temperature will overheat, causing the load overheat protection switch to trip.
The circuit problems are:
1. The circuit board is defective.
2. The temperature sensor is overloaded and the information is false.
3. Power wiring is loose and contact is poor.
4. The compressor start capacitor or start coil is blown.
Insufficient information can only be analyzed in this way. There are many other possibilities
It is recommended to find a professionalmaintenance to check.
I hope this helps you, don't hesitate to adopt it if you are satisfied. Thank you...