1. First, cut the flame retardant fabric to the same length as the pressed sheet. The length of the pressed sheet is 2mm.
2. Secondly, the fire protection is arranged under the pressing piece, and screws are used to tighten and fix the hole.
3. Then overlap the fireproof canvas at each steel corner.
4. After finally installing the flame retardant fabric, check the stability, cleanliness, air leakage, etc. from the engine exhaust port.
Is it OK to place a diesel generator in an exhaust shaft?
Whether or not to install an exhaust shaft mainly depends on your requirements for noise. The noise of a typical generator is 102 decibels. In order to avoid disturbing others, noise reduction treatment is usually necessary. Noise reduction treatment generally involves installing air inlet and exhaust shafts inthe wells ; The exhaust pipe is equipped with a heavy-duty silencer, and the smoke pipe is discharged out of the building and raised to the top of the building for discharge. In this way, the noise can generally reach less than 65 decibels. Smoke extraction shafts cannot be installed. Unless the smoke shaft is designed before the construction of high-rise buildings.
No. According to Query Machinery Network, the reasons are:
1. The oxygen content in the exhaust well is relatively low, which is not conducive to combustion and even poses a safety risk.
2. There are no effective protection measures in the exhaust shaft, which is prone to moisture, dust and corrosion, which is not conducive to the long-term operation of the equipment .
3. The exhaust shaft has high environmental requirements for noise and vibration. The noise and vibration ofDiesel generators are relatively large, which may have an impact on the living environment and staff health.