The gasoline generator often stalls automatically during operation. There are several reasons. One is a lack of oil, the other is a blocked oil circuit, the third is too high body temperature and the fourth is too heavy a load. These situations will cause the gasoline generator to automatically stall during operation.
If the machine is not very old or old, it is recommended to replace the spark plug and carburetor. If it is certain that the spark plug is not the fault, it is recommended that the oil supply line is not smooth and that it be cleaned or replaced.
Detailed information:
1. Drain all gasoline from the fuel tank and carburetor;
2. housing
3. Add new engine oil to the upper limit of the oil level on the oil dipstick
4. Close the choke and pull the starter handle to where resistance is felt;
5. Wipe the device clean and cover it with cardboard or a plastic cover to prevent dust.
Preparation and inspection before use of German Rennes digital inverter generator:
First step: add engine oil
Add engine oil model number For 5W-30 or 15W-40
Open the side cover, unscrew the oil dipstick and add special four-stroke gasoline engine oil to the middle of the upper and lower scale lines of the oil dipstick.
Tighten the oil dipstick and install the side cover.
Step 2: Add gasoline
Add gasoline type 90 or higher
Unscrew the fuel tank cap, add gasoline gasoline and addgasoline at 3 of the filter. More than 2/2 is enough.
Tighten the fuel tank cap
============Separation line===========
Steps to start the digital frequency conversion generator:
Step 1: Turn the motor switch to ON position.
Step 2: Turn the fuel tank cap air inlet valve to the ON position.
Step 3: Use your fingers to move the choke to the right to close it.
Step 4: Slowly pull the starting rope until it bites, then pull hard.
Step 5: Once the generator is successfully started, manually open the left choke.
The following is an explanation of how the German Rennes generator started:
I hope my answer will be useful to you!