How hot should the water temperature be in a diesel generator?

The water temperature of the diesel generator set is preferably around 80°, and the maximum temperature cannot exceed 95°! Remember not to let the temperature get too high or too low, as this will damage the generator! (For reference only: YANAN_ Diesel Generator Reply: 4000-080-999) The reasons why the water temperature is too high when the diesel generator set is running are as follows: 1. The water tank fan water does not turn. It's easier to do it. check if the water tank fan is working normally. The method involves turning on the refrigeration system. If the compressor has started but the fan still does not work, the fan must be faulty when the water temperature sensor is disconnected, the fan will work. operate alone to protect the motor. In this case, you can unplug the sensorwater temperature. 2. Poor heat dissipation of the radiator. This situation often occurs in summer. When inspecting, you just need to open the hood and observe if the radiator behind the bumper is filled with too many foreign objects. you must go to a repair shop for cleaning. 3. The thermostat cannot be opened normally. In this case, the coolant cannot circulate normally and cannot play a cooling role at all. The main manifestation is that the water tank and the return pipe are both at normal temperature (they should normally be warm). , and because the gas in the water pipes expands and the upper and lower water pipes become very hard. 4. Insufficient coolant This is a relatively easy situation to observe. Simply open the engine compartment and observe if the coolant level is replenished.ond to the requirements. 5. The water pump is not working properly. The water pump belt sometimes slips and idles due to prolonged use. When this problem occurs, the main characteristic is that it returns to normal after pressing the accelerator for a while. 6. Water temperature sensor, instrument and circuit abnormal. If the above problems have been eliminated, the excessive water temperature may be caused by water temperature sensor failure or instrument or circuit failure. It is necessary to go to the maintenance service point in time for detailed inspection.