If there is a leak in the components of the diesel generator set, the following seven methods can be used to remedy it:
Method 1. Method of treating leaks with paint flaking liquid : Diesel generator oil tank, water tank, crankcase, etc. If the joints are leaking, you can soak the paint chips in alcohol and apply the paint chip fluid to the clean joints.
Method 2: Use pumping to remedy leaks: When the bottom of the diesel generator fuel tank, cylinder head, gear chamber cover, engine crankcase rear cover and other paper seals leak, if the paper seals are intact and sealed. If the surface of the paper pad is clean, you can apply a layer of butter on both sides of the paper pad and tighten the bolts to prevent leakage; if you want to replace the paper pad with a new one, quenchz the new block of paper in diesel; oil for 10 minutes, remove it and wipe it, then wipe it on the joint surface and add it.
Method 3. Liquid sealant leak treatment method: In case of interfacial leakage and destructive leakage caused by solid seal defects on the diesel generator, apply liquid sealant to the solid seal fitting cleaned on the surface of the system. , after curing, a peelable film seal is formed which is uniform, stable and permanently adheres to prevent leakage.
Method 4. Treating leaks with anaerobic glue: When a leak occurs in ventilation bolts, studs, etc. On the diesel generator, anaerobic glue can be applied to the cleaned bolt threads or screw holes. quickly solidifies to form a thin film, filling spare parts; This method is used to deal with joint thread leaks.ts of high pressure oil pipes of diesel engines with better results.
Method 5. Dimensional Restoration Glue to Fix Leaks: In case of leakage in diesel generator shaft and sleeve, bearings and bearing seats, valves and valve stems, self-tightening oil seals, packaging, etc. ., dimension restoration can be used. The glue is applied to the worn parts of the cleaned joint parts, and after hardening it forms a thin film layer with wear resistance and high mechanical strength. It is then machined to restore the geometric shape and the joint. precision of parts, which can solve leaks.
Method 6: Add pads to remedy leaks: If oil is leaking from the seal of the diesel generator oil pipe joint, you can add a layer of thin plastic pads with a double-sided lubrication of dthem sides. seal and tighten it securely.
Method 7. Glue to repair leaks: If diesel generator fuel tanks, water tanks, oil lines and water pipes cause small leaks due to rupture or to blisters, pores, etc., glue can be applied to the cleaned damaged areas.