Yes? The Yineng New Energy Electric Mobility Car for the Elderly I just bought? A range extender is installed. The generator is too close to the brake oil pipeline and the generator does not have a water cooling system. It is hot and the generator is used for a long time. Later, due to the increase in temperature, the wall of the brake oil pipe became heated and expanded in the air. The brakes failed several times. I had to use the emergency handbrake and wait until the generator was turned off to cool down for half an hour before returning to normal.
The car generator is flooded with water, what should I do?
The molecular formula of water is H2O, which is a compound of hydrogen and oxygen, so hydrogen and oxygen can be decomposed from water. Hydrogen is a flammable gas and oxygen is a favorite gasbefore combustion. Combustion of both can produce thermal energy and thermal energy can be converted into kinetic energy. The combustion of hydrogen and oxygen ultimately produces water, which contains virtually no harmful waste gases. Therefore, scientists believe that turning water into fuel is more feasible and cleaner. Unfortunately, it is too difficult to develop specifically. It is not yet possible to invent a small machine that can not only continuously decompose hydrogen and oxygen in water, but also burn them to generate momentum.
On the other hand, the world now finds itself in an environment generally devoid of fresh, clean water. If water is turned into fuel, it will inevitably worsen water scarcity. Scientists now envision a future in which seawater could be turned into fuel.
What are the faultss common and treatment methods of diesel generator sets?
After the engine is flooded, initial corrective measures should be taken according to the specific situation to prevent the vehicle Secondary damage, find out the key to the problem and minimize damage to the car.
After understanding the specific situation, if you find that water has entered the engine, you should remove the spark plug and artificially prevent the fuel supply system from starting and d ignition, so that the water in the engine can be drained successfully.
Once the inspection is complete, use compressed air to treat the electrical connections inside the motor to prevent water from corroding them.
The parts to pay attention to are: the fuse box, the sensor socket and the body water accumulation area.
After cleaning, try the vehicle for yourselfensure normal operation of the engine during use.
1. The diesel generator set cannot start normally or the speed is too low
If there are starting problems, it may be as follows: Caused by the following reasons:
< p>1. This may be caused by insufficient battery power of the diesel generator. The electrolyte should be checked and charged before starting, and the battery can be replaced directly if necessary.2. This may be because there is water in the generator. At the moment you are not allowed to dismantle the generator without permission. Please contact the maintenance personnel of the diesel generator manufacturer, such as Yangzhou Fukangsi, immediately.
3. This may be because the lubricating oil temperature is low. At this time, the lubricating oil heater of the oil pan should bere installed.
2. Diesel generator set cannot start and smokes
If you are having smoke problems, it may be due to the following reasons:Causes:
1. This may be due to insufficient preheating before starting. Before starting the generator, it must be fully preheated. At the same time, carefully check the wires and the glow relay.
2. This may be due to the presence of air in the fuel. At this point, the air should be released and fuel can flow normally from the oil return pipe via the manual fuel pump.
3. This may be due to the wrong type of fuel being used. At this point, the original fuel should be replaced and the correct type of fuel should be used.
3. Diesel generator set automatic shutdown
When you encounter automatic shutdown problem, it may be due to the reasonss:
1. This may be due to insufficient fuel supply. Usually, the speed gradually slows down and gradually stops during normal operation, but various indicators (including pressure, water temperature, oil temperature, etc.) appear normal. At this point, fuel must be provided on time.
2. This may be due to obstruction in moving parts, such as piston failure. Usually, the engine oil is normal during operation, but the operation is difficult and accompanied by abnormal noises, the oil temperature rises and is accompanied by paint smell, and the water cannot come out of the cooling port. At this time, it is necessary to check the operation of the flywheel.