Specific steps:
The first step is to turn off the car engine to avoid injury.
The second step is to turn off the car engine, find the hood switch on the side of the cab door and pull it to open it.
The third step is to open the front hood and find the car battery in the engine room.
The fourth step is to disconnect the negative cable from the car battery to avoid electric shock during installation.
Step 5: Once the battery is off, remove the plastic cover from the outside of the belt on the side of the motor as shown below.
Step 6: After removing the plastic cover, remove the generator assembly.
Step 7. After removing the motor assembly, you will find a water pipe underneath, remove it.
Step 8: Since there is water in the water pipe,ntigel will spurt out after removing the sewer hose. Please be careful not to burn yourself.
Ninth step, then wait until the water drains and you can clearly see the thermostat directly, which means all the water in the water tank has been released.
Detailed information:
Routine maintenance of car water tanks:
1. The radiator should not be in contact with acids, alkalis or other corrosive properties.
2. It is recommended to use soft water. Hard water should be softened before use to prevent clogging and scaling inside the radiator.
3. When using antifreeze, in order to avoid radiator corrosion, be sure to use long-lasting anti-rust antifreeze produced by regular manufacturers and meeting national standards.
4. During installationn of the radiator, please do not damage the heat sink (sheet) or bruise the radiator to ensure heat dissipation capacity and waterproof.
5. When completely draining and filling the radiator, first turn on the engine block water drain switch. When the water drains, close it again to avoid blisters.
6. During daily use, the water level should be checked at all times and water should be added after stopping the machine to cool. When adding water, slowly open the water tank cover and keep the operator's body as far away from the water filling port as possible to avoid burns caused by high pressure steam ejected from the water fill port.
7. In order to avoid core rupture caused by freezing in winter, such as long-term parking or indirect parking, the water tank cover and interrDrain cover must be closed to drain all water.
8. The effective environment of the replacement radiator should be kept ventilated and dry.
Baidu Encyclopedia-Car Water Tank
Should the water in the water tank of the diesel generator be added before or after starting? Is there a difference?
It mainly depends on the pH value of your tap water. As long as the tap water isn't too hard, you'll be fine. However, the source of tap water in some places is groundwater, which is very hard and scales after being boiled. Therefore, this type of tap water is not suitable for hairdressing. Engine cooling water is used because the cooling water will be boiled and will continue to boil after boiling, making descaling easier. If there is scale when tap water is boiled, it is best not to use tap water. If you wantuse it, you can add a little vinegar to neutralize it and there will be no scale. It will not damage the engine or damage the engine. does not affect the heat dissipation of the motor.
? Diesel generator water tank is an important component of water-cooled engine. As an important component of the heat dissipation circuit of water-cooled engine, it can absorb cylinder heat and prevent diesel. motor against overheating. However, during use, users should pay attention that the water tank of the generator set cannot be without cooling water or add cooling water after starting.
If cooling water is added after the diesel generator set is started, important components such as hot cylinder liner and cylinder head will explode or deform due to sudden combustion and cold. Likewise, if water boilsante at 100°C is suddenly added to a cold body, the cylinder head will crack and the body will break.
Yatong reminds everyone that the correct operation method of the diesel generator water tank is: before starting the diesel generator, cooling water should be added first and hot water of about 60℃ should be added to the diesel engine. preheat it before starting.