Water gun bullets do not absorb enough water. The balls need to be soaked in clean water for about 3-6 hours until they become soft and filled with water before they can be used.
1. The position of the bullet entering the water gun is not precise. You must follow the operating procedures in the manual to install the ball correctly.
2. There is a problem with the water gun device. It is necessary to check whether the water gun is intact and whether it is loose or worn.
3. This involves bullet quality issues. The caliber of the bullet may be too big or too small and cannot work well with the inside of the water gun. It is recommended to replace it with high quality bullets.
The principle of the electric water gun is to use an electric motor to drive the bullet. Shoot the marbles in the trash can. IThere is an electric motor and a charger inside the electric water gun. The motor transmits power to the balls in the magazine via a gear transmission, so that they are compressed by the spring in the magazine. When the trigger is pressed, the spring releases. energy and pushes the balls into the magazine. The balls spring out. At the same time, the motor will also drive a fan to expel air into the magazine, forming a strong airflow, allowing the bbs to fire faster and farther. The principle of the electric water gun is simple, easy to understand and use. It is a very popular toy gun.