The canal floating bucket is generally a type of canal buoy, used to mark the canal beach, indicate shoals, obstacles or indicate special-purpose river navigation aids.
These unique floating barrels are usually made of plastic or other materials and have specific shapes and colors to clearly mark the direction and boundaries of the channel in the water. They can be used to help ships maintain the correct course and avoid the risk of collision or grounding while sailing.
It should be noted that different waterways may use buoys of different colors and shapes to distinguish different types of water surface signs. Therefore, in specific application scenarios, it is necessary to judge the buoy according to the specific situation. .The meaning of the bucket.
It’s about relying on buoyancyball tee to close the toilet water inlet valveWhen the water in the toilet rises to a certain position, the buoyancy. water lifts the ball and connects the ball to it. The water inlet valve connected to the ball is closed, and when the water level drops and the ball falls, the water inlet valve connected to the ball is opened to allow the water to flow. to enter the toilet.
Toilet float valve repair steps:
Please make sure the toilet water shutoff valve is in the closed position.
After removing the piston from the valve, you will see one or two seals (or type 0 sealing rings). If one of these parts fails, water will continue to flow past the valve plunger and the toilet will continually flow. Please check all seals and replace them if damaged.
If the float valve is sealed, replace ite entirely. Turn off the water source to the toilet at the water shut-off valve, then flush, drain the water from the tank, unscrew the float arm from the old float valve, then remove the water fill hose from the water supply pipe.
Look for the connector nut or slide nut under the water tank, where the water inlet hose enters the bottom of the water tank. Loosen the connection nut, remove the water inlet pipe, and then use an adjustable wrench to tighten the lock nut or lock nut under the water tank, which is located above the sliding nut, and use another wrench to tighten the float valve shaft in the water tank. .the base of.
Remove the old device from the water tank, remove the gaskets from all connections inside and outside the water tank and save them. New valves may come with new seals, but old onesParts should be kept until the water tank is used. the new device is installed to prevent the new device from being damaged during installation.
Insert the new float valve into the hole in the water tank. After installing the gasket inside the water tank, tighten the lock nut on the outside of the water tank so that the inner gasket is firmly pressed against the hole in the water tank. achieve a sealing effect, but do not tighten too much.
Replace the connection nut and water inlet pipe, reinstall the floating arm, then insert the injection pipe into the water supply pipe.
Let the water flow through the toilet water shut-off valve again, check for water leaks in various parts, and of course, check if the floating ball scratches the back wall of the water tank. .
The new float valve eliminates the float armt the floating ball and uses a cup of material. When the water tank is full, the material cup floats and cuts off the water source. The water level of the water tank can be adjusted by adjusting the position of the feed cup on the pull rod. One of the advantages of this type of float valve is that it can discharge water at full speed when the water tank is flushed until it is fully charged. Until it is full. It then immediately turns off the water so there is no noise while the float arm gradually closes the valve like some toilets do.