First check the generator output voltage. If there is no voltage, then check: starter, fuel injector, oil, carbon brush, generator speed, etc.
The first step is to add engine oil to the mark on the oil dipstick. (Less inverted cylinder, no more tiling and oil leaking.)
Add water and fill it. Turn on the machine and run it for 3 minutes to check the water. If you are not satisfied, add more water. (The cylinder is missing)
Battery, 24V. Connect the positive pole to the starter and the negative pole. Diesel, remove air.
The second step is to start the new car and idle it for 10 to 20 minutes. This will help the oil to be distributed to each hole, ensure the lubrication system and reduce wear on the machine. . Check the oil pressure gauge. Do not start the machine without pressure. Find and eliminate the cause.
Slowly increase the speed, reach 30 Hz, approximately 900 rpm and remain idle for 20 minutes. Increase to 50 Hz, 1500 RPM and sit idle for 20 minutes.
The third step is to complete the break-in of the new car. The speed should be reached at 54-58 Hz, add load and drive the load. The HZ should reach 50 Hz. 50 Hz is the standard of 1500 rpm and the drive load is 50 Hz.
Maximum ammeter should be 90A, diesel engine is 56KW and the motor is 50KW. The maximum cannot exceed 90A, the motor will burn and the three guarantees will not be given. . Diesel engine load should be 80%. The maximum load will cause greater wear on the machine.
The third step is to pull the load. Always check the water meter, oil meter and oil pressure meter. The water meter can reach a maximumm of 95, the oil meter can reach a maximum of 105. and the oil pressure meter cannot be less than 0.2.
The fourth step is to stop the car. You must first close the door that sends the charge. You cannot directly close the throttle and close the charge. The speed should slowly decrease and the temperature should drop. 1000 rpm, 40 Hz, stop for 5 minutes and slow down to idle. It takes 10 minutes to park.
When parking with a load and driving at high speed, the car may explode. The car temperature is high, the water cannot be cooled in time, and the engine oil cannot be lubricated, resulting in the cylinder. explode. No guarantee.
The fifth step is to drain the water after parking the car in winter. If the water does not escape, the water will freeze and break the machine body, and the warranty will be void.
The sixthhe step is to check the engine oil and water before driving.