The difference between the upper rotor and the brake of a hydrogenerator

Introduction The difference between the rotor cylinder and the braking of a hydrogenerator The difference between the rotor cylinder and the braking of a hydrogenerator is as follows. The main purpose of pushing the rotor before starting the turbine is to establish an

The difference between the upper rotor and the brake of a hydrogenerator

The differences between the upper rotor and the brake of a hydrogenerator are as follows. The main purpose of lifting the rotor before starting the turbine is to establish an oil film between the thrust tiles and the mirror plate to prevent dry friction between the two, resulting in burning of the tiles.

1. When the hydro-generator unit is stopped, the brake is applied when the speed drops to 30% of the rated speed. Usually the unit uses an air brake and some small units use electric braking. .

How to scrape the tiles of a hydraulic generator

The working surface and non-working surface of the feed water pump push tile have the following differences:

p>1. The working surface faces the generator, the pump inlet pipe is at the transmission end, the pump outlet pipe is at the free end, the thrust bearingis at the end of the free end and the axial thrust direction of the pump is from the free end to the transmission end.

2. The non-working surface faces the machine head.

Are steam turbine thrusters and thrust tiles the same thing?

When scraping push tiles, the first step is rough scraping. Typically, a wide flat scraper is used to scrape high spots over a large area. After several scrapings, the surface of the tiles will be uniform. and a smooth contact state. Then proceed with fine scraping. When scraping finely, use a spring scraper to scrape in sequence according to the contact situation. The knife marks should be clear and the patterns of both scrapings should be approximately vertical. Every time you scrape, you should scrape all the biggest and brightest spots, open the contact pointsmedium and leave the small dots temporarily intact. This will cause the large dots to be split into multiple smaller dots, and the smaller dots will be. will become large dots and small dots will appear without any dots. Generally, the contact points on the tile surface should be 1-3 points/cm2. When the contact point meets the requirements, the oil inlet edge can be cut according to the drawing, and the edge without oil inlet can be scraped and chamfered. Are you satisfied with the response?

Thrusts and thrust shoes on steam turbines are the same thing.

The thrust plate establishes the dead center of rotor expansion, ensuring that the axial clearance between the moving and static parts is within the design range. It is widely used in steam turbines, hydraulic turbines, water pumps, etc. The function of the turbine thrust shoe is to determine the posiaxial position of the rotor in the cylinder.

Thrust pads are generally composed of two thrust washers or several thrust washers and several rolling elements. Generally, thrust washers are divided into shaft parts and seat parts. Rolling elements are generally the most common type. consisting of an iron or copper cage as a whole.

Detailed information

Material used for push tiles:

Billet steel + Babbitt alloy (also called black gold ), with black gold It can melt when the shaft temperature reaches about 110 degrees, increasing the moving space of the large shaft, thereby protecting the large shaft and preventing dry friction of the thrust caused by large axial displacement of the big tree. Next comes tin bronze and billet steel + fluoroplastic (this material has a low coefficient of friction, is suitable for temperahigher tures, does not need to scrape the tiles and will not burn the tiles due to oil cutting), etc.

Baidu Encyclopedia Push Tile

  • Popular Focus
  • Where is the cheapest battery wholesale?

    Where is the cheapest battery wholesale in Tangxia, Sanyuanli, Baiyun District? There is an enterprise specializing in the independent production of electric vehicles in Tangxia, Sanyuanli, Baiyun District, Baiyun Sanyuanli Avenue, Baiyun Sanyuanli Street
    08-02
  • Four 3.7V lithium batteries in series and parallel produce 7.4V/4.4A. How to reduce it to 4.8V/4.4A?

    Four 3.7V lithium batteries in series and parallel produce 7.4V/4.4A. I personally think it is impossible to reduce it to 4.8V/4.4A. Because the discharge platform of lithium batteries is generally set
    08-10
  • What are the materials of the negative electrodes of lithium batteries?

    What are the materials of the negative electrodes of lithium batteries? The main commercial applications of lithium batteries include graphite, which is a sheet of copper used to guide current and which does not react. another safe
    08-02
  • The difference between 18500 and 26500 batteries

    What is the difference between 18500 and 26500 batteries? The answer above is 18650. The person asking the question should ask what is the difference between 18505 and 26500 batteries. In the case of Fuant ER1
    08-02
  • What does 3.7V 80mAh written on a lithium battery mean?

    What does 3.7V 80mAh written on a lithium battery mean? 3.7 V, 80 mA = 0.08 A, H means 1 hour, or 3600 seconds. Taken together, it is
    08-02
  • How long does a lithium battery (cell phone battery) last?

    How long does a lithium battery (cell phone battery) last? The lifespan of mobile phone batteries, under normal conditions of use and without serious impact, the lifespan set by the manufacturer must be 5 years.
    08-02
  • Will lithium batteries explode when charging?

    Will lithium batteries explode when charged? Will lithium batteries explode when charged? Lithium battery explosions usually occur during the charging process, because the negative electrode material of lithium batteries is graphite or other carbon materi
    08-02
  • Parameters of lgdas31865 lithium battery

    Parameters of lgdas31865 lithium battery The parameters of lgdas31865 lithium battery are as follows: LGDAS31865 is a model 18650 lithium battery with a capacity of
    08-02
  • What are the main components of lithium battery electrolyte?

    What are the main components of lithium battery electrolyte? The composition of lithium battery electrolyte is shown below. 1. Ethylene carbonate: molecular formula C3H4O3. Colorless transparent liquid (>35℃), room temperature
    08-02
  • Who are the lithium battery manufacturers in Shandong?

    What are the lithium battery manufacturers in Shandong? Shandong Shengyang Power Supply Co., Ltd. and Shandong Weineng Environmental Protection Power Technology Co., Ltd. 1. Shandong Shengyang Power Supply Co., Ltd. is located in Shengyang, Qufu City.
    08-02
  • Types of drone batteries available in 2024

    Part 1. Types of drone batteries available in 2024In 2024, drone batteries have advanced significantly, offering a range of options to cater to various needs in
    07-30
  • How long does it take to charge 26650 battery?

    How long does it take to charge a 26650 battery? The charging time for a 26650 battery is generally between 3 and 6 hours, but the precise time depends on the power of the charger and the capacity of the battery. in general
    08-02
  • For what?Sure, here's an article based on the phrase "For what?

    The simple yet profound question, "For what?" often serves as a gateway to deeper reflections on purpose and intention. It is a query that invites us to delve into the reasons behind actions, decisions, and circumstances that shape our lives and the wor
    08-02
  • Choosing the Right Cart Battery

    This comprehensive guide will walk you through everything you need about cart batteries, from understanding different types to making an informed purchase decision.
    08-02
  • 30mAh~500mAh 3.7 V Li-ion Battery

    Welcome to Ufine's collection of 3.7V lithium-ion batteries ranging from 30mAh to 500mAh. Explore a diverse range of compact and lightweight batteries suitable for various electronic devices,
    08-02
  • Here are 10 essential facts about drone batteries for 2024.

    10 Key Facts About Drone Battery for 2024 In 2024, drone batteries have advanced significantly, offering a range of options to cater to various needs in the consumer, commercial, and industrial sectors. Below are the primary types of drone batteries avai
    08-02
  • Could you please explain the difference among IMR, ICR, INR, and IFR 18650 batteries?

    What is the Difference Between IMR, ICR, INR, and IFR 18650 Battery?In 18650 batteries, discerning the differences among IMR, ICR, INR, and IFR types is fundamental for tailored and efficient battery usage. These distinct
    08-02
  • Safety considerations for cart batteries

    Selecting the ideal cart battery is crucial for ensuring optimal performance and longevity of your electric vehicle or vaping device. This comprehensive guide w
    08-01