Diesel generator set coolant is used in the cooling system to directly cool the diesel generator set. It is generally appropriate to use soft water, such as rainwater, tap water or clarified river water. If well water or other groundwater (hard water) is used directly, because it contains more minerals, scale will easily form in the water cavity of the diesel generator set, affecting the cooling effect and causing a breakdown. If conditions limit the availability of hard water, it should be softened before use. Softening method: 1. Boiling method: boil water to precipitate; 2. Add 0.67g of caustic soda per liter of water, stir and precipitate, then use the top layer of clean water. When the diesel generator set is used in subzero environmental conditions, preStrict precautions must be taken to prevent the coolant from freezing, which could lead to failure of associated parts. Therefore, every time the diesel generator stops working, the coolant in each part must be drained. For models using the Zhuanggong circulation cooling system, antifreeze coolant with a suitable freezing point may be used depending on the local minimum ambient temperature. When using flammable antifreeze coolant, since both ethylene glycol and alcohol are flammable, attention should be paid to fire prevention. Before using antifreeze coolant in a diesel generator set, the dirt present in the cooling system should be cleaned to avoid the generation of new chemicals that would affect the cooling effect.stiffening. For diesel generator sets using antifreeze coolant, it is not necessary to drain the coolant after each shutdown, but its composition should be renewed and checked regularly. If there is too much scale and dirt in the cooling system of the diesel generator, it can be cleaned with cleaning fluid. The cleaning fluid can be prepared from water, soda and a glass of water. That is, add 40 g of soda and 10 g of a glass of water per liter of water. When cleaning, pour the cleaning fluid into the cooling water cavity of the diesel generator set, operate the vehicle until the outlet water temperature is above 60 degrees, continue to operate for about two hours, stop, then release the cleaning fluid. Once the diesel generator set has cooled, rinse it twice with fresh water et clean, drain it, then add cooling water and start operating until the outlet water temperature reaches more than 75 degrees. Stop the machine to drain the waste water, and finally add new cooling. water.
Does the water in the water tank of the diesel generator set need to be replaced once used and can the diesel generator set work continuously?
Different, the diesel water pump unit is a diesel engine which directly drives the water pump, and the diesel generator set with water pump is a diesel engine which drives the generator. The motor powers the water pump motor. to operate the water pump. However, they each have their own advantages and disadvantages in terms of direct water pumping efficiency. High and fuel efficient, but it doesn't have the flexibility of a generator to produce electricity and then drive the engine. The genator can produce electricity. If there is no oil, you can also use electricity to pump water since it is separate. If you're not pumping water, it can also be used as a power station! In other words, the diesel water pump is dedicated, if the latter is more flexible! Changsha Sanchang Pump Industry
Anthracene, this water tank does not need to be changed after one use. It can be replaced after running for a while, for example around February. As long as there is water in the water tank during operation and the machine is not burned out, you will be fine. If it is a generator, it can run continuously because it has many generators that can produce electricity in turn. If it is a single machine, it should run for a while and let the machine rest and cool down. byAvoid burning the cylinder andpiston! !