1. If it is a complete replacement, the water tank can be removed.
It is easy to disassemble. You just need to loosen the flush connector at the bottom of the water tank, then remove the connector connecting the high pressure hose. Once the two are separated, lift the entire water tank with both hands to remove it. Because the water tank is hung on the wall.
When installing a new water tank, make sure that the new water tank hangs in the same position as the old one. If it's not right, move the wall hangings. After hanging the new water tank, simply connect the upper and lower flush pipes and the high pressure water inlet pipes.
2. If there is a problem only with the water parts inside the water tank, you can replace only the water parts inside the tank. It's a little more complicated. Carefully remove the rconnection between the internal water fittings and the box, then install the new water fittings.
Detailed information
According to current national regulations, special funds for the renovation of rural toilets are supported by local finances. In response to this situation, the departments concerned. of our city cooperated, integrated the resources of relevant departments, and organically combined the renovation of rural toilets with poverty alleviation, the renovation of dilapidated rural housing, poverty alleviation and relocation, and the overall improvement of the rural environment, so that rural toilet renovation works can be effectively promoted.
“When we renovated the toilet, we were only responsible for choosing the address and digging the pit. The engineering team did the rest, and we didn't spend any money. Zhu Yi said that engineering. He also repainted the walls of his house, and the whole house seemed to have changed.
According to the relevant official of the Bishan District Health Commission, the district allocated more than 25 million yuan from major livelihood special funds in 2018 for three years of rural toilet renovation and subsistence allowance to rural households. scattered households housing extremely poor people and disabled poor families), each household will receive a grant of 1,500 yuan for the renovation of three-size septic tanks in dilapidated level D houses.
Each household will receive a grant of 1,200 yuan for the renovation of dilapidated toilets in dilapidated Class C houses for the four categories of people, and a grant of 1,000 yuan for each household for the renovation of dilapidated toilets in dilapidated Class C houses. the housesdilapidated for people not belonging to the fourth category (C quality toilet houses, D quality septic tanks). Other rural retail households receive a subsidy of 800 yuan.
People's Daily Online - Nearly 80% of Chongqing Farmers Popularized Sanitary Toilet
During the maintenance process of the excavator, the engine and the air conditioning system have poor heat dissipation. , causing the water temperature to be too high, which will result in the following malfunctions:
1. When the excavator is idling, the engine water temperature gauge shows too high temperature, the electronic fan operates at high speed. speed too long and the engine noise increases. The problem is more obvious when the air conditioner is turned on when the temperature is too high.
When servicing the excavator: check if there is too muchdust between the condenser and the water tank, and clean it carefully with high pressure air to ensure that the water tank and the condenser have good heat dissipation performance. Pay attention to wiping off the dust between the condenser and the water tank at ordinary times.
2. When the air conditioner is turned on when the temperature is too high, the idle speed will be unstable and the speed will increase. fluctuates too much, and the sudden acceleration will be weak and the engine will make abnormal noise.
When maintaining the excavator, check the temperature difference between the upper and lower water pipes of the water tank. If the temperature difference is too great, check the thermostat and water pump for openings. is a loss of speed.
The temperature difference between the upper and lower water pipes of the water tank should not be too largeante.
3. After a hot car is off for more than ten minutes, it is not easy to start the car when starting; When the hot car is driven, it sometimes turns off automatically.
Solution: After warming up the car, check the water return condition of the water return pipe at the upper end of the antifreeze water storage tank. If the water return is not flowing or blocked, the water temperature will increase. be too high.
4. The air conditioning cooling temperature is very cold when the car is cold, but the air conditioning cooling effect is not obvious when the car is hot, and there is a loud resonant hum; the air conditioning system.
Due to the irregular addition and replacement of antifreeze during excavator maintenance, the engine water channel and water tank will be blocked in advance and the water temperature will be high. L'Antifreeze should be replaced every two years and original accessories should be used when replacing and adding.
5. When the hot car is idling, the air conditioning compressor clutch is frequently disconnected or even disconnected, causing the hot car's air conditioner to not cool. The high pressure end of the excavator maintenance air conditioning system is too high; the air conditioning refrigerant or air conditioning refrigerant lubricant is overfilled; the self-adjusting function of the internal air conditioning compressor fails, resulting in high excessive pressure