1. Make sure that no sharp objects such as nails, steel wires, etc. are exposed. does not protrude from the platform where the prepressurized water bag is placed to avoid puncturing the water bag.
2. Place the pre-pressed water bag on the platform and spread the water bag to ensure that the bottom and surrounding sides of the water bag are flat and wrinkle-free to prevent the water bag from or reduced in size after filling with water.
3. Close the bottom water outlet valve, screw the cap, remove the valve key to prevent the water bag from pressing the key during the water filling process, break the water bag, open the upper water. Inlet valve and the water inlet valve passes through the quick connector. Connect to the water pipe and fill with water.
4. After the water injection reaches the predetermined length, width and height via water pump or pressure pump, close the inlet pipe valvewater and stop the water injection in time to prevent the water bag from bursting.
5. After pre-pressure is used, fold the pre-pressure water bag and place it after draining the water.
6. When using a pre-pressed water bag, if there are scratches, use a grinding wheel to polish the damaged surface, evenly apply the glue recommended by the manufacturer, and at the same time apply it evenly to the Covering Material for the cover. Hold together and squeeze for ten minutes, then leave for 24 hours before use.
7. Use an electric soldering iron. Plug in the electric soldering iron and heat it for fifteen minutes. Press the coating material and the damaged area together at high temperature with the electric soldering iron. evenly during the heat sealing process and leaves no gaps to prevent water leakage.