I think that not only is it entirely possible, but depending on the height of the water height of the tank, if electricity is generated several times in a row, not only the potential energy of origin but also greater kinetic energy will exist. If you want to get the best results, you need to change the turbine design and connect it to pressure lines, as well as a whole new set of new solutions. You can log on to cctv.com to read my blog posts: "Suction Hydroelectric Power Generation Method", "The World's Greatest Technology Mistake, Leading to 99% of the Best Waste of energy", etc.
Thermal plant Can the water be used for swimming?
Sea water can also be used for water cooling in thermal power plants, but sea water cannot be used for steam power plants.udières. Thermal power plants have a dedicated workshop for this. purify water quality, and it should be monitored regularly during operation, to avoid exceeding the standard. The main task of this major is to replace, regenerate, soften and desalinate fresh water to meet pure water quality requirements, and then deoxygenate it. . During operation, chemicals must be added according to parameters to allow salts to solidify and precipitate into sewer lines to purify water. You know that the teapot used for watering at home scales after prolonged use because the quality of the water is too hard and contains too much salt if you use a boiler with an evaporation capacity of several hundreds or thousands of tons per hour. , the direct consequence will be the boiler. The pipes were blocked and the boiler was put on fire.ut. If sea water is used as boiler water, the water treatment work will be more rigorous.
Nuclear power plants use seawater to cool the water, mainly because most nuclear power plants are built by the sea, so it is more convenient to use seawater
Of course, whether it is a nuclear power plant or a thermal power plant, when using seawater cooling water, you must pay attention to the anti-corrosion problems. There are many electrolytes in seawater with the ability to corrode. is much stronger than that of fresh water.
How does hydroelectric power plant + water run the engine?
Water used (produced) by power plants is roughly divided into the following types: p>
1. “Raw water” extracted from rivers and lakes cannot be used without treatment. (Mainly usedused for circulation cooling)
2. The raw water is precipitated and filtered to become "domestic fire water", which is equivalent to "tap water" and can be used for bathing.
3. Domestic firefighting water is then treated with chemicals to become “industrial water” and should not be used. (Used for equipment cooling)
4. It will then be transformed into “demineralized water” and cannot be used. (Used for boiler working fluid)
The movement of water in the process of up and down water flow drives the rotation of the generator. Hydroelectric power plants typically have dams in order to increase the water level difference on both sides of the generator, thereby increasing the gravitational potential energy of the water, causing the upper water to generate greater kinetic energy when it flowsrs from lower places, thus favoring the hydroelectric generator. to be more efficient. It runs faster