When there is a fire inside the generator, jump the generator first;
Connect the fire hose to the fire hydrant and open the water door ;
The generator maintains 300 rpm. .
The fire hose gets in the way during maintenance. Typically, only the water line at the end of the generator is left and air leaks are blocked.
When using, remove the cap and connect the fire hose.
Carbon dioxide, carbon tetrachloride, and dry powder extinguishers are all acceptable.
When electrical equipment catches fire during operation, the power should be turned off first and then turned off. If the power cannot be turned off quickly, extinguishers such as carbon dioxide, carbon tetrachloride, 1211 extinguishers, or dry powder extinguishers can be used. When using, a sufficient safety distance must be maintained.For equipment of 10 kV and less, the distance must not be less than 40 cm.
When extinguishing an electrical fire without turning off the power supply, you should use the following fire extinguishers: Carbon tetrachloride fire extinguisher - It has a good extinguishing effect on fires in electrical equipment. no Does not burn or conduct electricity. Carbon dioxide fire extinguisher - most suitable for extinguishing fires in electrical and electronic equipment. Carbon dioxide has no corrosive effects and will not damage equipment. Dry Powder Fire Extinguisher – It combines the benefits of carbon tetrachloride and carbon dioxide. It is suitable for extinguishing electrical fires and has a fast extinguishing speed.
Be careful not to use acid-based or foam-based fire extinguishers, as the extinguishing fluid is conductive and people holding the extinguisher will receive an electric shock. This liquidIt strongly corrodes electrical equipment and is difficult to remove afterwards.