If oil gets into the generator, it theoretically cannot be used anymore because there is a problem with the generator seal. Over time, the generator will no longer be able to produce electricity or the structure. will get stuck.
A large amount of oil entering the generator will cause the following dangers:
1. Eroding generator insulation and accelerating insulation aging.
2. Too much dust will affect the heat dissipation of the enameled wire and the engine oil will be stained with dust. If the temperature is too high, the enamel of the enameled wire will melt, causing failure and short circuit. The generator was scrapped.
3. If the water content in the oil is large, the humidity of the hydrogen inside the generator will increase, causing the generator insulation to become damp. In severe cases, this can cause a short circuit between phases inside the generator. Generator.
Precautions for automobile alternators
Frequently clean dirt and dust from the outside of the alternator, keep it clean and well ventilated, and frequently check the tightness of various fasteners related to the alternator If necessary, tighten all the screws in time.
The tension of the drive belt must be appropriate. If it is too loose, it will slip easily and result in insufficient power production; if it is too tight, it will easily damage the belt and generator bearings. When installing the battery, be careful not to install it incorrectly. Usually install the positive. Wire first and not the ground wire, otherwise the diode will burn out easily. When using an integrated circuit regulator, the ignition switch should be turned off immediately when the engine is not running.