Can be cleaned with detergent. Pour a small amount of detergent into the water bag, then pour half of the water, cover the mouth, shake and vibrate vigorously to produce a large amount of foam, leave for a while, shake again, repeat several times , And ; finally, pour out the water. Then turn on the faucet and fill it with water. Do not turn off the water. Continue filling until the washing foam in the bag is completely drained.
1. Make sure that there are no sharp objects (protruding nails, steel wires, etc.) on the platform where the pre-pressurized water bag is placed to avoid puncturing the water bag . 2. Place the pre-pressurized water bag on the platform and spread the water bag to ensure that the bottom and surrounding sides of the water bag are flat and wrinkle-free to avoid the size of the bag water is reduced after being filled with water. .
3. Close the lower water outlet valve, vRemove the cap, remove the valve key (to prevent the water bag from pressing the key and breaking the water bag during the water filling process), open the water inlet valve upper water and pass the water inlet valve. Connect the quick connector to the water pipe and fill it with water.
4. After the water injection reaches the predetermined length, width and height through the water pump or pressure pump, close the water inlet pipe valve and stop the water injection. water in time to prevent the water bag from bursting.
5. After pre-pressure is used, fold the pre-pressure water bag and place it after draining the water. Note: When using a pre-pressed water bag, if there are scratches, use a grinding wheel to polish the damaged surface, evenly apply the glue recommended by the manufacturer, and at the same time apply the glue evenly to the covering material, cover it together and pressz it for ten minutes, then leave it for 24 hours before use; or use an electric soldering iron. Plug in the electric soldering iron and heat it for fifteen minutes. Use the electric soldering iron to press the coating material and the damaged area. together at high temperature. Pay attention to uniform pressure during the heat sealing process and do not miss any gaps to avoid water leakage.