Yes.
After researching public information, we learned that water is needed in the cooling system of natural gas power generation.
Natural gas generator set is an ignition type gas machine that uses high calorific value gas such as natural gas as fuel. Based on the non-supercharged model, a supercharged system and an intercooling system are added. The cooling system adopts a separate high and low temperature cycle to cool the high temperature components such as cylinder, body and cylinder. head, and the low temperature cycle cools the supercharged gas, air and oil cooler.
When you boil water without damage, the water is not charged.
But it heats up quickly because the whole rod is in water, which easily leads to electricity leakage and makes the waterelectrified, it is therefore prone to accidents.
To heat quickly, both ends of the electric heating wire are connected to the power cord respectively. After power on, current flows through the heating wire and the heating wire generates heat. When immersed in a liquid, heat is rapidly dissipated through the liquid, causing the liquid to heat up quickly.
Poor product quality, improper use, non-standardization and lack of attention to products are the main reasons why "rapid heating" frequently causes disasters.
"Heat fast" has a simple process and poor security performance, so it is better not to use it. If you must use it, choose one that is state approved, heats up quickly, and isn't cheap. Before use, be sure to check if there ishas an alarm device and if the circuit is aging. When using the "heater", please be careful. First insert the heater into the thermos bottle, then plug in the power. stored in the bottle should be moderate, consistent with the neck of the bottle or It may be slightly lower than the neck of the bottle to prevent it from drying out if heated too quickly. Someone must monitor boiling water to prevent it from boiling over if boiled for a long time, causing it to explode or catch fire. After the water is boiled, unplug it in time and wait 1 minute for the heat to cool down quickly before removing it.