Answer: There is a lot of water stuck in the engine block. For example, the valve cover, behind the oil cooler, etc. The cylinder must be cast in one go. After the mold is put into the sandbox, there are also air holes left to clean the waste inside the molding after the molding is finished. Once these holes are completed, they can only be plugged with plugs to isolate the engine coolant and lubricating oil from the collusion.
Is there a water blockage behind the cylinder block of Weichai P12?
2024-08-07 19:12:01
Introduction Is there a water blockage behind the Weichai P12 cylinder? Answer: There is a lot of water blockage in the engine block. For example, the valve cover, behind the oil cooler, etc. The cylinder block must be cast in one step during casting.
