Generate electricity throughout the day (nonsense), 0~4EU/s
Output. How to get maximum power: Climb to the upper limit, which is the highest place, and place the generator one space below the upper limit. Don't keep any other blocks in the 9X9X7 range of the generator
Of course, this is impossible, because you still need at least two cable blocks, so the maximum is around 3.7EU /s
. PS: The transmission voltage of the new version of the tin cable has been adjusted from 3EU/t to 5EU/t, so it is possible to build high-efficiency wind power plants.
Transversal working range of the generator.
PS: The fewer things in the working range, the greater the energy output.
Wind energy generates on average 250 EU per MC day, but this is closely linked to its environment. Not only do you have to place it high up, but you have toAlso remove the windshield.
-Wind force: called wind force
The minimum value of wind force is 0, the maximum value is 30, it changes every 128 ticks (about 6, 4 seconds), and each change is +1 or -1 (cannot be reduced to a negative number).
If the current wind strength is 0 to 20, there is a 10% chance of increasing.
If the Qianfeng is between 10 and 30, there is a 10% chance of reduction.
The reduction rate of wind intensity from 0 to 9 is
(current wind intensity)%
The probability of increasing wind 'Wind intensity from 21 to 30 is
< p>(Wind strength at 30 currents)%The maximum safety value is 5 settings: 191 altitude, 2 cable blocks, no rainy days.
If the wind turbine's power value is greater than 5, there is a 0% to 0.1292% chance of damaging 0 to 4 iron ingots (broken).
Electricity=
S
*（Y
-
64
-
C)/750
, S is the wind force, Y is the height, and C is the number of blocking grids in the range 9*9*7.
When it thunders, the power increases by 50% (power*1.5), and when it rains, it increases by 20% (power*1.2)
The side with the copper The ring material is attached to that which can be heated. The copper ring material side of the equipment absorbs heat, such as solid/liquid fuel heaters, liquid heat exchangers, etc., and attaching it to the radioisotope heater is equivalent to using a It It is not necessary to use a radioisotope generator directly. Liquid heat exchangers are typically used in nuclear power plants.