If it is -35 degrees at night, then 5W-30 oil is not sufficient and its low temperature fluidity cannot meet the requirements
You must use 5W-30 oil. engine oil around 0W-40, and the low temperature fluidity is -40 degrees. Nothing is wrong.
There are two possibilities for the other milk-like condition. One is that cylinder flushing causes water in the oil, and the other is oil grade. problem that occurs like this at low temperatures. The flush cylinder should be checked. You know, open the water tank cover, start the engine and adjust the speed. If water comes out quickly after increasing the speed, it means the cylinder is broken. is flushed and needs to be repaired. Otherwise, you can replace it with a 0W oil motor.
1. Check for antifreeze in the generator water tank, diesel in the oil drum and engine oil.nerator.
2. Check if the generator battery switch is closed, if the speed switch is in the low speed position, if the power switch behind the generator is closed, and if the generator power switch is electricity the transformer in the room is closed.
3. During a power outage, convert the internal and external lines of the main transformer to generate electricity:
1. Turn on the generator battery switch.
2. Turn the generator start knob to start the generator. After waiting for the generator to start normally, Kejian Construction Machinery recommends adjusting the low speed gear to the high speed gear and paying attention to the generator starting normally. the generator voltage is 380 volts.
3. When the voltage stabilizes at 380 volts, turn on the generator, then turn on the power switchimentation.
Fourth, after completing the above three steps, turn the power switch of the transformer in the power generation room to supplement the power supply to the west hospital area.