When installing the generator water heater: open a screw at the water pump on the oil motor body, then open a screw at the water outlet. This way you can add water for heating. Generally, it has 2KW, 4KW and others, this is determined according to the power of your generator (For reference only: COMLER generator (?: 4006-183-789) generator diesel will answer your question)
Will the failure of the water heater of the diesel generator cause high temperature of the diesel engine?
It's very simple, it Just open a screw at the water pump on the diesel engine body, then remove the water from the outlet. Open a screw, so you can add water heating. Generally, there are 2 KW, 4 KW and others. It depends on the power of your. Generator. For details, please refer to Baidu HI.
The raison for which the Cummins 150 kW generator set emits abnormal noise during cold start.
The function of the water heater of the generator set:
When the temperature ambient temperature of the engine is below 4°C, during the start-up phase, the engine coolant/lubricating oil may condense to a solid state and lose its lubricating or cooling effect, thus damaging the engine. Therefore, a heater must be installed on the engine, to ensure normal starting and operation of the engine.
The heater has a light indicator function that can indicate different states of the heater. Three heating temperature levels can be adjusted, with dry burning and overheating protection functions. Once the heater is turned on, the water pump runs for 5 seconds. If the water temperature does not reach the set temperature and the heater does notIf it does not dry, the heater starts heating until the water temperature reaches the set temperature, then the heater. enters automatic state when water temperature drops to reset. When the temperature drops below the temperature, the heater restarts heating.
Common faults and solutions are as follows:
1. If water gets into the fuel, it must be carefully checked.
2. The machine does not burn well when cold
3. Injector pressure is uneven
For these problems, only one method will solve this problem. fix the problem The solution is to install a water heater for the generator. Because it is too cold, use a heater to heat the body temperature above 26 degrees, preferably 40 degrees. It's normal. It's too cold and the diesel atomization is not good! Once thebody temperature warms up, everything is fine. The main reason is that the machine is too cold and the injected fuel is not completely burned and is discharged into the tailpipe with the exhaust. After some cylinders operate normally, the temperature rises and the unburned oil in the exhaust pipe is burned, causing deflagration. Once the temperature is normal, there will be no more problem.
Reference documents:
http://www.fdjdl.cn