They are not interchangeable. The technical requirements of the two products are inconsistent. Wind power antifreeze has extremely high requirements for electrical conductivity. As long as one of them does not meet the standards, it will cause metal corrosion! The cost of wind power antifreeze is much higher than that of car antifreeze, so Cheruiwei reminds everyone not to add inferior products just to be cheap, because the gain will make up for the loss .
The temperature of the cooling water is relatively high.
p>(1) This is usually caused by dust accumulation on the radiator outside the cooling water tank. In case of heavy dust, debris on the outer surface of the radiator or during operation of the device will be sucked into the water tank by the cooling fan, causing blockage, blockageaffecting ventilation and leading to poor heat dissipation. At this point, you just need to clean the radiator outside the water tank and clean the debris from the device to resolve the problem.
(2) After being used for a long time, the generator cooling fan connection belt will gradually age and become easily broken or inelastic, resulting in abnormal blowing capacity. At this point it is necessary to replace the damaged belt. When replacing, all belts should be replaced together instead of just one.
(3) The coolant content is very low. It is necessary to check the factors causing the lack of cooling water. Check the tightness of the cooling water tank and each cooling water pipe. In the event of a leak, it must be repaired immediately. Then add sufficeplenty of coolant.
(4) The use of a coolant that does not meet the requirements causes the accumulation of scale, rust and other substances in the cooling water pipes, resulting in impedes the circulation of cooling water and causes an increase in water temperature. Coolant is usually water and antifreeze or water and anti-rust fluid. The pH value of water should be between 6.0 and 8.02_, and pure water is generally used. For cooling systems that have been seriously deposited and clogged, it is best to add 0.5L of detergent for every 7L of cooling system volume, mix it with clean water, start the machine and run it for 90 rain, circulate cooling water to clean. then use clean water to circulate it Xian to preventcleaning agent remaining in the pipe will cause corrosion of the pipe.