I will only use solar generators and hydroelectric generators.
1. Solar generators, as the name suggests, can only produce electricity in sunny locations, and of course not at night. First place it on the ground and connect it with fiberglass wires as shown in the picture.
Then connect the energy storage box as shown in the picture.
The left gear has a smaller capacity; the middle speed is faster and has larger capacity; the right gear has a larger capacity.
2. Hydroelectric generators, as their name suggests, can only produce electricity in water. They are placed in water and connected with fiberglass threads. As picture shows.
Hold down Shift before logging in, otherwise it will open. Then connect the energy storage box as shown in the figure.
At present, the speed is unified and the capacity is as above.
That's it, put the dead equipment into the energy storage box and it can be charged.
How to install a domestic hydroelectric generator?
If you use an electric pen to measure the two wires with load, they should be single phase from what you said.
The reason the charger burns out is because the voltage is too high. I suggest you use a multimeter to measure the voltage or check the voltage level of the connected device to make sure it is 220V and then adjust the output voltage. If the output is 380V, a transformer is required.
You must first confirm the information: \x0d\1. How high is the water level? (This is the vertical height from the water intake to where you plan to install the turbogenerator)\x0d\2. How muchof cubic meters per second the flow rate (or what diameter of water pipe can be used to supply continuously) (water to full pipe)\x0d\3. Can the water source withstand it? Affected by rainy season and dry season, what is the flow during the dry season? \x0d\To clarify the above points, you can consult the manufacturer of the micro hydroelectric generator, they will recommend a suitable machine for you. \x0d\If it is a water source with low water head and large flow rate, the "scroll axial flow turbine generator" is your best choice. \x0d\If it is a water source with high head and low flow, and the flow changes significantly in winter and summer, the "double-tube oblique impact turbine generator and double jet” should suit you. \x0d\However, the principle is that you must first confirm the relevant information about your water source.