Installation methods and precautions for sinks:
1. Select sinks:
Choose stainless steel sinks that are smooth in appearance, strong and durable. When purchasing, check whether the welded part of the sink is intact, whether there are cracks in the joints with the pipes, whether the sealing ring is dislocated or damaged, and whether the water leak will discovered after a few days of use. Check if the silencer block is degummed. Finally, check if all the sink accessories are complete.
2. Install the sink:
1. First install the water inlet pipes and faucets.
2. Place the sink on the counter, seal the gap between the sink and the counter, then seal the filter basket and overflow to ensure the sink is waterproof and firm.
3. Install the corresponding hanging pieces and the connections between the spaces must be equal.
4. Install the sewer pipes.
5. Placea sink on the countertop (pay attention to edge sealing and overall firmness)
6. Seal the overflow hole and filter basket (be careful of water leaks). )
7. Install corresponding hanging parts (to avoid small gaps that cause the tank to shake and cause residual water leakage)
8. Perform drainage and edge sealing tests (the connection spaces). should be uniform and pay attention to appearance)
< p>3. Details to consider when installing the kitchen sink1 The installation of the sink should be placed in the last step. kitchen decoration
2. The water in the water pipe must be drained during installation (otherwise it will be damaged in the future) There are water leaks and rust)
3. The faucet must be installed firmly (if it is not firm, gaps may occur, resulting in water leakage)
4.After the installation is completed, the sink basin should be washed (remove impurities during installation)< /p>
IV. Notes:
1. When installing the sink, the water in the pipe must be drained cleanly. This will prevent water pipes from rusting and leaking in the future.
2. The sink drain outlet should be left in the sink cabinet and the angle valve should be installed before installing the sink.
3. Before installing the faucet, wrap the faucet in a plastic bag to avoid scratching the exterior wall of the faucet.
4. The hot and cold pipe openings of the faucet should be clearly distinguished. Close the water tap before installation to avoid water burns.
5. The threaded pipe should be tightened when installing the sink to avoid water leakage due to poor pipe sealing. But be careful not to damage the screws by applying too much force.