Do you want to ask “What should I do if DJI Mavic 3 is not turned on? »
1. First of all, DJI Mavic 3 is not turned on. Check whether the generator wiring is normal and whether it is loose or damaged.
2. Second, the internal parts of the generator become damaged or aged, resulting in the inability to produce electricity normally. The generator needs to be replaced or repaired.
3. Finally, the generator circuit becomes damaged or aged, resulting in the inability to produce electricity normally. The circuit must be checked and repaired or replaced.
Can the DJI T40 generator be connected to power for external use?
DJI T40 generator model: BAX601-30000mAh-52.22V.
The temperature of the charging environment is between 5℃ and 40℃.
The built-in battery life is 3.3 hours.
External battery life is 2.7hours.
The charging method uses a USB-C fast charging charger with a maximum power of 65W (maximum voltage 20V). It is recommended to use a DJI portable charger.
Charging time for built-in, built-in and external batteries is 2 hours (off state follows the official charging method).
How to reset the maintenance light on the DJI T50 generator
No. The DJI T40 generator is specially designed for drone endurance, and its output voltage and current are different from conventional power adapters. Connecting it directly to an external electrical device may damage the device or cause safety issues. To ensure the safety and normal operation of the equipment, the DJI T40 generator is only used during the battery life of the drone and cannot be used outside of the power supply. When using, follow the instructionsOfficial DJI user instructions and instructions to ensure proper use and safe operation.
Here is how the DJI T50 generator maintenance light resets:
1. Verify that the maintenance light has stopped flashing: After maintenance is completed, wait for the maintenance light to stop flashing.
2. Press the reset button next to the maintenance light: Once the maintenance light stops flashing, use a tool to press the reset button (usually a round button) next to the maintenance light and continue pressing above.
3. Wait for the light to change: press and hold the reset button for about 5 seconds. At this time, the light next to the maintenance light should change. Specific changes of indicator lights may vary between different models, please refer to the user manualwe.
4. Release the reset button: After waiting for the light to change, release the reset button. At this time, the maintenance light should be back to zero.