Five “fears” in car maintenance
1. Fear of "dirty" parts
There are fuel filters, oil filters, air filters, hydraulic oil filters. and various types of water tank filters and radiators, air-cooled engine block and cylinder head radiators, cooling radiators and other heat dissipation parts.
2. Auto parts that are afraid of “heat”
Engine pistons, rubber seals, triangular tapes, tires, etc. and coils of electrical equipment such as starters, generators, regulators, etc. and vehicle bearings.
3. Auto parts feared to be "missing"
Engine valve lock plates, connecting rod bolts, flywheel bolts, cotter pins, lock screws and insurance installed on the drive. shaft bolts Lacking anti-loosening devices such as blades or rspring washers, as well as water tank caps, oil port caps and fuel tank caps.
4. Auto parts that are afraid of "oil"
Paper filter element for engine dry air filter, triangular tape, brake shoe, dry clutch friction plate, brake belts, generator starter and carbon brushes and some rubber products.
5. Auto parts that are afraid of "pressure"
Tire cards, rubber oil seals, triangle tapes, oil lines, etc. I hope you don't make these five "fear" mistakes when repairing and maintaining your car. This can reduce unnecessary problems on your car and help prolong the use of your car.
The solution to inconsistent oil pressure from the air side seal on both sides of the generator is as follows:
1. Check the stanchion componentsncheity: Make sure the sealing components are correct. on both sides of the generator (such as O-rings or gaskets) are not damaged or worn.
2. Check the oil seal: The oil seal plays an important role in preventing lubricating oil leakage.
3. Check the oil system: Ensure normal operation of the oil system, including oil pumps, filters and oil passages.