Pacific Automotive Network 1. First, remove the mounting bolts on the generator shaft. 2. Then pull the generator idler pulley outward to make it easier to wind the belt. 3. Then wrap the generator belt around the generator shaft. 4. Then wrap the belt around the two idler pulleys of the generator. 5. Then install the generator shaft housing and the generator belt is installed.
If there is an abnormal noise in the engine compartment of the car, it is usually because the belt is loose or of poor quality, so check the engine belt first. If there are multiple belts in the car and you cannot determine which belt is the problem, you can start the car first and then pour water on the belt. If the abnormal noise disappears, there is a problem with this belt. I can take a look. Is it cowardly orquality is bad?
The motor belt makes an abnormal noise. Dousing it with water will increase its viscosity, which effectively improves the viscosity of the belt. But after the water dries, the belt will return to its original state. This is the principle of belt watering. Whatever the timing belt or chain, they are invisible from the outside and are covered by a side cover. You can tell this by looking at the material and tightness of the cover that covers the timing belt or chain. If the cover is plastic and just attached with a few simple screws, there is the timing belt inside.
If it is made of iron or aluminum, has many screws and is tightly sealed, it is a chain. The belt cover only blocks dust and foreign objects, while the chain cover not only blocks foreign objects, butalso has a sealing function because it is lubricated by engine oil and contains organic oil. Look for the exposed accessory belt, which is the large cover near the accessory belt.
Look at the service manual. In the maintenance content, if it says how many kilometers to replace the timing belt, it is the belt. If it's not indicated, it's the channel.