When installing the China Junjie 4a13 engine belt, you need to remove the screws and replace the old belt.
1. Remove the screws from the headlight assembly.
2. Unplug the Zhonghua Junjie headlight.
3. Loosen the tensioner.
Four. After loosening the Zhonghua Junjie tensioner, you can remove the Zhonghua Junjie generator belt.
5. Install the new Zhonghua Junjie generator belt.
6. Lock the China Junjie tensioner and the operation is completed.
1. First, apply lubricating oil to the contact surface between the cylinder block and the water pump sealing ring to facilitate the subsequent suspension of the belt.
2. Stretch the pulley at the generator shaft outward to make it easier to wind the belt later.
3. Loosen the bearing at the generator timing wheelur, otherwise the belt cannot be suspended.
4. Use a wrench to tighten the idler pulley under the generator to prevent the belt from slipping after installation.
5. Next install the generator belt.
6. After installing the generator belt, install the generator shell so that the belt hangs.