Based on daily maintenance, maintenance can be carried out every six months or a year
1. Perform a complete inspection of water, electricity, oil, gas, etc. of the generator set to confirm whether the unit is normal;
2. Test the machine without load for 5 to 10 minutes to ensure the unit is fully lubricated; judge the working status of the unit by listening, seeing, smelling, etc. .;
3. Replace the air filter, diesel filter, engine oil, oil filter, water filter, oil-water separator filter element and other consumables;
4. tank coolant and water tank treasure;
5. Add battery fluid or distilled water
6. Once maintenance is complete, inspect the generator again and clean it; >
7. Test the machine without load for 5-10 minutes and inspect each unit. Save settingsperformance, offer rational suggestions and accept customer acceptance.
For more information, please log in to the relevant website: http://www.fdjdl.cn
1 If there is water in the fuel , you should check it carefully. .
2. The machine does not burn well when cold
3. Injector pressure is uneven
For these problems, only one method will solve this problem. fix the problem The solution is to install a water heater for the generator. Because it is too cold, use a heater to heat the body temperature above 26 degrees, preferably 40 degrees. It's normal. It's too cold and the diesel atomization is not good! Once the body temperature warms up, everything is fine. The main reason is that the machine is too cold and the injected fuel is not completely burned and is discharged into the exhaust pipe.t with the exhaust. After some cylinders operate normally, the temperature rises and the unburned oil in the exhaust pipe is burned, causing deflagration. Once the temperature is normal, there will be no more problem.
Reference documents:
http://www.fdjdl.cn